Table of Contents
Advertisement
© Panduit Corp.
2020
6: OPERATION
Follow this operation procedure to correctly apply cable ties with the PATMFM4.0 Fixture. To begin,
follow the Start Up Checklist below to assure safety and optimum system operation.
6A: Start Up Checklist
1. Is the PAT4.0 Dispenser connected to the air supply?
2. Is the PATMFM4.0 Fixture air regulator connected and branching off of the PAT4.0 Dispenser air line?
3. Is the PAT4.0 Dispenser air pressure set properly?
4. Is the PATMFM4.0 Fixture air pressure set properly?
5. Is the PAT4.0 Dispenser loaded properly?
6. Is the PAT1M4.0 or PAT1.5M4.0 Tool properly mounted into the Tool Cage?
7. Is the Tool Cage and Tool properly mounted onto the Fixture?
8. Is the Tip Deflector installed onto the Tool?
9. Is the Tool Cage airline connected to the Fixture's orange air supply quick connect fitting?
10. Is the PHM Feeder Hose securely connected to the PAT1M4.0 or PAT1.5M4.0 Tool, and PAT4.0
Dispenser?
11. Is there a "waste receptacle" placed underneath and behind the Tip Deflector to catch cable tie waste?
12. Is the fixture's actuation paddle unlatched and in the vertical "operational" orientation?
13. Is the PAT4.0 Dispenser powered on?
14. Is the Operator Menu on the PAT4.0 Dispenser displaying "ready" in the green bar on top of the screen?
The Operator Menu must be displaying the ready state for the tool to dispense cable ties.
6B: Cable Tie Installation
1. Review and follow all Safety Practices on Pages 8-12. Wear adequate eye protection.
.
2
Ensure that the Tool Cage Airline is properly connected to the quick connector located on the underside
of the fixture. Check that the EI Communication Cable and air regulator line are connected between the
PAT4.0 System and the Bench Top Fixture. Confirm the PHM Hose is properly connected between the
PAT4.0 Dispenser and the Tool within the PATMFM4.0 Tool Cage.
OPERATION MANUAL
25
PATMFM4.0
ENGLISH
Advertisement
Table of Contents
