Install Pat1M4.0/Pat1.5M4.0 Tool Into Tool Cage - Panduit PATMFM4.0 Operation Manual

© Panduit Corp.
2020
Installing PATMFM4.0 Fixture Assembly onto the work surface:
5E. Install PAT1M4.0/PAT1.5M4.0 Tool into Tool Cage
1. Back off the two thumbscrews located towards the back of the tool cage.
2. Once the thumbscrews are loosened, the Rear Lower Tool Support Block will disengage from the Tool Cage
Assembly.
3. Insert the PAT1M4.0 or PAT1.5M4.0 into the Tool Cage, ensuring that the Tool properly aligns within the
Front Upper and Lower Tool Supports. Proper installation can be verified by ensuring the Tool Cage
Actuator Trigger aligns well with the PAT1M4.0 or PAT1.5M4.0 finger trigger.
4. Reinstall the Rear Lower Tool Support Block and thumbscrews. Hand-tighten until the Tool is supported
within the Tool Cage and does not shift.
OPERATION MANUAL
15
x8 #6x1.0"
WOOD SCREWS
USE APPROPRIATE SHEET
METAL FASTENERS AND
HARDWARE
IF MOUNTING TO METAL WORK
SURFACE.
(NOT PROVIDED)
PATMFM4.0
ENGLISH