Table of Contents
Advertisement
© Panduit Corp.
2020
2. Prevent unintentional starting. Ensure the actuation paddle is in the actuation-position
before connecting to a power source or turning on the PAT4.0 System.
Unlatching the paddle whilst the PAT4.0 system is powered can cause an unintended tie cycle to
occur.
3. Remove any adjusting key or wrench before turning the power tool on.
A wrench or a key left attached to a rotating part of the power tool may result in personal injury.
4. Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts.
Loose clothes, jewelry or long hair can be caught in moving parts.
5. If devices are provided for the connection of dust extraction and collection facilities,
ensure these are connected and properly used.
Use of dust collection can reduce dust-related hazards.
6. To prevent unintentional injury, DO NOT place the PATMFM4.0 where a ladder is required
for access.
3D: Power Tool Use and Care
1. Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the job better and safer at the rate for which it was designed.
2. Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
3. Disconnect the plug from the power source and/or the battery pack from the power tool
before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
4. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
5. Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
6. Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to
control.
7. Use the power tool, accessories and tool bits, etc. in accordance with these instructions,
considering the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a hazardous
situation.
OPERATION MANUAL
12
PATMFM4.0
ENGLISH
Advertisement
Table of Contents
