Sync Settings Submenu; Underscan; Colorspace; Gamma - Barco ImagePRO-SDI Installation Manual

Sync Settings Submenu

This menu allows the user to specify the sync types for the current output. The submenu is illustrated below:
The Sync Out menu item selects among the five possible output sync types:
CSync, +H+V, +H-V, -H+V, -H-V. The default setting is -H-V for most formats. For NTSC, PAL, RS-170 and RS-343
the default is Csync with equalizations on.
The SOG/Y item selects among: Off, Standard and Tri-Level for RGB color space. If the Output color space is YPbPr
the Off selection is not available since sync information is always part of the Y output.
The Serrations menu item sets serrations in the output composite sync pattern during V Sync time. Values are On or
Off. The default setting is On.
The Equalization menu item sets equalization pulses in the output composite sync pattern around V Sync time.
Values are On or Off. This menu is n/a if the output is not interlaced.

Underscan

Underscan reduces the output image area by the specified percentage. Range is 0% to 15%.

Colorspace

The Colorspace selection sets the output mode for analog component outputs. Choices are: RGB, YPbPr.

Gamma

This selection allows the user to specify the Gamma associated with the current output. The value range is 1.0 to
3.0, in steps of 0.1. Default gamma values are stored with each video format.

Sharpness

The Sharpness selection sets the scaler's sharpening (or softening) amount. This setting has a default value of 0,
and sets the scaler to its optimum sharpness level. The sharpening range extends from -10 (most softening) to
+10(most sharpening).
Manual # 26-0302000-00 / Revision E
SYNC SETTINGS
> Sync Out
SOG/Y
Serrations
Equalization
[val]
[val]
[val]
[val]
ImagePRO – Multi Format Image Processor
39