Barco ImagePRO-SDI Installation Manual page 31

TM
Connect ImagePRO to 115 VAC power using the power cord supplied with the unit. Locate the power switch on the
power entry module at the rear of the unit and turn the power on. While the main board is initializing, "please wait" will
be displayed and the front panel keys will be turned on and off. When initialization is complete, the Setup Menu will
be displayed.
VORSICHT ein Ausrufungszeichen innerhalb eines gleichwinkeligen
Dreiecks dient dazu,
den Benutzer auf wichtige Bedienungs-und
Wartungsanweisungen in der Dem
Great beiliegenden Literatur aufmerksam zu machen.
WARNING
The rear panel ON/OFF switch does not
disconnect the unit from input AC power. To facilitate disconnection of
AC power, the power cord must be connected to an accessible outlet
near the unit. Building Branch Circuit Protection: For 115 V use 20 A,
for 230 V use 8 A.
WARNING
™
When the ImagePRO is used in the 230-volt mode, a UL
listed line cord rated for 250 volts at 15 amps must be used
and must conform to IEC-227 and IEC-245 standards. This
cord will be fitted with a tandem prong-type plug.
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
17