Barco ImagePRO-SDI Installation Manual page 101

System and Ethernet Remote Commands
Command:
DMSG mode
Description: Sets Debug message display mode.
Parameters: mode - DMSG mode [0-1] Off | On
Query:
DMSG?
Returns the Debug message display mode in the format
= mode
Example: DMSG 1 (Sets Debug message mode to On)
DMSG? (Queries the DMSG mode)
Command:
EDHCP mode
Description: Sets DHCP mode.
Parameters: mode - DHCP mode [0-1] Off | On
Query:
EDHCP?
Returns the DHCP mode in the format
= mode
Example: EDHCP 1 (Sets DHCP mode to On)
EDHCP? (Queries the DHCP mode)
Command:
EECHO mode
Description: Disable/Enable echo on telnet window (for Microsoft Windows XP telnet window, echo must be
disabled.)
Parameters: mode - Disable/Enable telnet echo (0 / 1)
Example: EECHO 0 (Disable echo on telnet window)
Command:
EIP xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
Description: Set static Ethernet IP address, subnet mask and default Gateway IP
Parameters: IP address – xxx.xxx.xxx.xxx (xxx: [0-255])
Subnet mask – yyy.yyy.yyy.yyy (yyy: [0-255])
Gateway IP – zzz.zzz.zzz.zzz (zzz: [0-255])
Query:
EIP?
Returns the Ethernet IP address, Subnet mask and Gateway IP in the format (Note that if DHCP is used,
Subnet mask and Gateway IP is not used by the ImagePRO.)
= xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
Example: EIP 192.168.000.200 255.255.255.000 192.168.000.001 (Sets IP address to 192.168.0.200, subnet
mask to 255.255.255.0, and default Gateway IP to 192.168.0.1)
EIP? (Returns IP address, subnet mask and Gateway IP)
Command:
EMAC?
Description: Query Ethernet MAC address for the ImagePRO. Note that each ImagePRO unit will have a
different MAC address.
Parameters: None
Returns: MAC address. xx:xx:xx:xx:xx:xx
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
87