Power Connection - Barco Nio 5MP Installation And User Manual

Display installation
To change from landscape to portrait, turn clockwise.
4.
Notice:
Before installing the Nio driver, put the display panel in portrait
orientation. Then install the driver and reboot the PC.
From that moment on, the Nio system will adapt the image orientation
to the display panel orientation at each reboot.
So, if you change the panel orientation after the initial installation, you
have to reboot the PC to adapt the image orientation to the panel
orientation.

Power connection

To connect the power:
To get access to the connectors, remove the connector
1.
compartment cover by pulling down the 2 clips at the top of the
cover.
Connect the output of the 12V DC power supply to the DC input of
2.
the display.
Connect one end of the proper power cable to the AC input of the
3.
12V DC power supply.
34
Figure 11