Display Controller installation
Figure 5
If you decide to use a separate VGA monitor as your boot monitor, you
Nio
must disable the BarcoMed
's on-board VGA capabilities by moving
the jumper to the bottom two pins.
Nio
Caution: To use multiple BarcoMed
controllers in a single host with
Nio
VGA enabled, you should enable VGA on only ONE of the BarcoMed
Nio
display controllers and disable VGA on ALL the other BarcoMed
display controllers.
Examples of PCI slots
Nio
Although the BarcoMed
display controller has a 64 bit PCI connector,
it functions as a 32 bit board. It may be installed in either a 32 bit or 64
bit slot with no loss of functionality. Figure 6 on page 30 illustrates the
types of slots so that you can correctly identify which one to use for the
Nio
BarcoMed
display controller and which ones not to use.
29