Barco Nio 5MP Installation And User Manual page 30

Display Controller installation
Installing the BarcoMed Nio display controller
Install the BarcoMed Nio controller in your computer
following these steps:
Turn off the power to your computer and disconnect the power
1.
cord, however make sure that the computer chassis is still
grounded.
Remove the chassis cover according to the manufacturer's
2.
instructions. Be sure to observe safety warnings.
If you have decided to use the on-board VGA capabilities of the
3.
Nio
BarcoMed
BarcoMed Nio display controller" on page 28), you must now
remove any VGA controllers that are currently installed in the
computer.
Install the BarcoMed
4.
either 32 bit or 64 bit (see figure 6 above, for examples of slots).
Be sure that the display controller is seated firmly in the slot.
Secure the card to the chassis with the PC's I/O panel mounting
5.
screw, and replace the chassis cover.
Connect the primary display to the connector marked "VID 1" on
6.
the BarcoMed
(see figure 7 on page 31). For a dual-headed BarcoMed
30
Figure 6: PCI and RAID Controller Slots
controller (see "Using the VGA capabilities of the
Nio
display controller into a free PCI slot,
Nio
display controller using the provided DVI cable
Nio
setup,