Barco Nio 5MP Installation And User Manual page 75

the "Extend my Windows desktop onto this monitor" checkbox,
but do NOT click the "Apply" button at this time.
If you installed your BarcoMed
(default for Windows 2000) there will be one rectangle for the
virtual display representing the two heads controlled by each
Nio
BarcoMed
If you installed your BarcoMed
(default for Windows XP) there will be a rectangle representing
each head controlled by each BarcoMed
will be true even if you have only one display connected to your
Nio
BarcoMed
cannot be enabled at the same time unless their display properties
match. If necessary detach the second display of the BarcoMed
Display Controller you are working with by right clicking on the
rectangle that represents it, deselect "Attached" and click the
"Apply" button.
Tip: Since Windows 2000 and Windows XP will not let you detach
the primary display connected to a particular controller, you may
need to temporarily make another display the primary display.
Caution: If you have a single display configuration and you have
enabled DualView, Windows will not allow you to attach the
second head. This is normal and not a bug.
For the display which is still attached click on the "Advanced"
4.
Button.
Select the "Adapter" tab and then click on the "List All Modes."
5.
button. Select the resolution and refresh rate that your
supports from the dialog box and click "OK".
Tip: In the Adapter box, the Adapter string shows if this display is
the First View or the Second View attached to the Display
Controller. Please make a note of this, so that you can arrange the
displays in the correct order later if necessary.
Click "OK" on the bottom of the Adapter Control Panel. If the "OK"
6.
button on the bottom of the Adapter Control Panel is not visible,
Nio
display controller.
Nio
controller. Both displays of a display controller
drivers in SingleView mode
drivers in DualView mode
Nio
display controller. This
Troubleshooting
Nio
Nio
display
75