Cable Routing - Barco Nio 5MP Installation And User Manual

Cable routing

Routing the signal cables
• Bind the cables in the connector compartment together with the
cable tie inside the connector compartment.
• Put the connector compartment cover back on the display. Pay
attention that the signal cables are positioned under the bulge
in the cover.
• Push the cables into the clips on the rear of the tilt & swivel foot.
• Bind the cables together above and under the foot, by means of
the 2 velcro strips attached to the inside of the foot cover
(packed inside the accessory box).
• At last, put the foot cover back in place.
Figure 15
Display installation
37