Preferences Setup; Television Type; Audio/Subtitles/Disc Menu; Blocking Function (Child Safety) - Clatronic DVD 582 Instructions For Use Manual

DVD 582 - GB 30.09.2003 12:31 Uhr

Preferences Setup

The DVD player must be in the stop mode or the DVD di-
sc drawer must be open in order for you to be able to call
up the preferences menu. To put the player in the stop
mode press the STOP button twice.
Type of Television System
Adjust the video output such that it corresponds to the te-
levision system to which the device is connected:
1. . If you are using a PAL television set, select the PAL
output signal;
2. If you are using an NTSC television, select the NTSC
output signal;
3. Select MULTI if your television set has a multisystem.
Please Note:
In order to produce the best DVD picture we recommend
the use of a multisystem television for the playback of
DVD films in the "MULTI" mode.

AUDIO/SUBTITLES/DISC MENU

The DVD player will show the AUDIO, subtitles or DISC
MENU in your language. If the disc does not contain the
language selected by you, the player will display the lan-
guage on the CD which is included in the factory settings.
Please Note:
The audio and subtitle language depend on the langua-
ges available in the disc menu.
Blocking Function (Child Protection)
Seite 37
If one of the parental control functions is selected, the
"PASSWORD VERIFY PAGE" appears on the screen. If
the disc that is to be played
back has been recorded with a
blocking function, you can enter
a minimal age depending on
the classification of the disc or
your own personal wishes. For
example, PG-R has been sel-
ected: You will see an image as
shown on the right - enter the password in order to set up
the blocking function. No DVDs can now be played back
with a classification higher than PG-R. Parental control
classifications are listed from a low to a high level. Child-
ren are the lowest level, parents the highest.

Factory Settings

If you select RESET all functions are returned to the ori-
ginal factory settings of the device.

Version

When this function is selected you will receive information
on the versions.

Password

This should be selected to change the code. The screen
shows that you first have to enter the old password and
then the new one. The new password then has to be re-
entered as confirmation.
37