NetApp HCI Manual page 89

requires VMware vSphere Enterprise Plus licensing.

Ports A and B are unused on the H610C.
Network function
Management
iSCSI-A
iSCSI-B
vMotion
H615C compute nodes
NetApp HCI expects the following network configuration for H615C nodes.
This configuration is only supported when used with VMware vSphere Distributed Switches (VDS), and
requires VMware vSphere Enterprise Plus licensing.
Network function
Management
iSCSI-A
iSCSI-B
vMotion
Find more information
• NetApp Element Plug-in for vCenter Server
• NetApp HCI Resources page
• SolidFire and Element Software Documentation Center
smartd
Disable the
smartd
By default, the
should disable this service on all compute nodes after you deploy NetApp HCI.
Steps
1. Using SSH or a local console session, log in to VMware ESXi on the compute node using root credentials.
2. Stop the running smartd
/etc/init.d/smartd stop
3. Prevent the smartd
vmkernel
vmk0
vmk1
vmk2
vmk3
vmkernel
vmk0
vmk1
vmk2
vmk3
service on NetApp HCI compute nodes
service periodically polls the drives in your compute nodes. You
service:
service from starting at boot:
vmnic (physical interface)
vmnic2 (Port C), vmnic3 (Port D)
vmnic3 (Port D)
vmnic2 (Port C)
vmnic2 (Port C), vmnic3 (Port D)
vmnic (physical interface)
vmnic0 (Port A), vmnic1 (Port B)
vmnic0 (Port B)
vmnic1 (Port A)
vmnic0 (Port A), vmnic1 (Port B)