NetApp HCI Manual page 237

Check description
Is DRS enabled and fully
automated?
Is DPM disabled in
vSphere?
Is HA admission control
disabled in vSphere?
Is FT enabled for a VM on
a host in the cluster?
Are there critical alarms in
vCenter for the cluster?
Are there generic/global
informational alerts in
vCenter?
Are management services
up to date?
Are there errors on the
current ESXi node in
vSphere?
Is virtual media mounted
to a VM on a host in the
cluster?
Is BMC version the
minimum required version
that has RedFish support?
Is ESXi host up and
running?
Do any virtual machines
reside on local ESXi
storage?
Node/cluster
Cluster
Cluster
Cluster
Node
Cluster
Cluster
HCI system
Node
Node
Node
Node
Node/VM
Action needed to
resolve
Turn on DRS and make
sure it is fully automated.
Turn off Distributed Power
Management.
Turn off HA admission
control.
Suspend Fault Tolerance
on any affected virtual
machines.
Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
You must update
management services
before you perform an
upgrade or run pre-
upgrade health checks.
Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
Unmount all virtual media
disks (CD/DVD/floppy)
from the VMs.
Manually update your
BMC firmware.
Start your ESXi host.
Remove or migrate local
storage attached to virtual
machines.
Knowledgebase article
with procedure
See this KB. NOTE: If you
have standard licensing,
put the ESXi host into
maintenance mode and
ignore this health check
failure warning.
See this KB.
See this KB.
See this KB.
No KB needed to resolve
issue.
No KB needed to resolve
issue.
No KB needed to resolve
issue. See this article for
more information.
No KB needed to resolve
issue.
No KB needed to resolve
issue.
No KB needed to resolve
issue.
No KB needed to resolve
issue.
No KB needed to resolve
issue.