Before Putting The Device Into Operation; Assembly And Siting - Lauda ECO Silver E 4 S Operation Manual

6

Before putting the device into operation

Please note:
–
The device can be operated up to an ambient temperature of 40 °C.
–
A higher ambient temperature can have a negative effect on the cooling output of the thermostats used.
–
When putting the chiller into operation after a lengthy shut-down period, up to 30 minutes may pass until
–
the rated refrigerating power is available depending on room temperature and device type.
6.1

Assembly and siting

Always comply with the following safety information:
Warning!
Affix the symbol "Hot surface".
The ECO thermostat is used as:
Immersion thermostat (optionally with cooling coil and/or pump connection set),
–
Heating thermostat (heating bath and circulation thermostat),
–
Cooling thermostat (cooling/heating bath and circulation thermostat).
–
Assembly as immersion thermostat
Warning!
26 / 124
Falling / toppling equipment on sloping surfaces / table edge
Crushing of hands and feet
Only site the device on flat surfaces, not near the edge of

the bench or table.
Push the screw clamp on the underside of the control head into
–
the guide rail.
Insert the thermostat with the screw clamp into the tempering
–
vessel ( 9) and screw it tightly to the bath edge by turning the
knurled screw.
With plastic baths the tubular heating element must not contact
–
the bath wall.
Ensure that the ventilation opening at the back of the control
–
head is free.
Keep a distance of at least 20 cm free on all sides of the device.
–
Control head drops into bath
Make sure that the control head mounting is securely joined

to the bath.
ECO Silver
Electric shock hazard
10/2019 i