Before Putting The Device Into Operation; Assembly And Siting - Lauda E 4 G Operating Instructions Manual

ECO GOLD
6

Before putting the device into operation

Please note:
−
The device can be operated up to an ambient temperature of 40 °C.
−
A higher ambient temperature can have a negative effect on the cooling output of the thermostats used.
−
When putting the chiller into operation after a lengthy shut-down, up to 30 minutes may pass until the rated
refrigerating power is available depending on room temperature and device type.
6.1

Assembly and siting

Always comply with the following safety information:
Warning !
Affix the symbol "Hot surface".
The ECO thermostat is used as:
− Immersion thermostat (optionally with cooling coil and/or pump connection set),
− Heating thermostat (heating bath and circulation thermostat),
− Cooling thermostat (cooling/heating bath and circulation thermostat).
Assembly as immersion thermostat
Warning !
25/08/2011/ YACE0088
Falling / toppling equipment on sloping surfaces / table
Crushing of hands and feet
•
Only site the device on flat surfaces, not near the
edge of the bench or table.
−
−
−
−
−
Control head drops into bath
Electric shock hazard
•
Make sure that the control head mounting is securely
joined to the bath.
Before putting the device into operation
edge
Push the screw clamp on the underside of the control
head into the guide rails.
Insert the thermostat with the screw clamp into the tem-
perature control vessel (
tightly to the bath edge with the knurled screw.
With plastic baths the tubular heating element must not
contact the bath wall.
Ensure that the ventilation opening at the back of the
device is free.
Keep a distance of at least 20 cm free on all sides of the
device.
9) and screw the clamp
21