7.3
Display representation
The ECO thermostats offer you intuitive menu guidance. In the following the possible window views and the sym-
–
bols used are explained.
7.3.1
Basic window
Basic window in the normal display
–
1
29.
73 °C
DISPLAY MENU
Apart from the normal display of the basic window, there is another display. This includes in addition a further status
–
display. With the soft-key bar activated changeover between the two display representations is obtained by pressing
the left soft key. With both displays the soft-key bar disappears if no key has been pressed for at least ten seconds.
The display of it can be reactivated by pressing any key.
Basic window in the expanded display
–
1
29.85 T
int
29
.73 °C
DISPLAY MENU
With a connected external sensor and its selection as the control variable, the basic window with the expanded
–
status display is always active.
10/2019 i
–
30.00 °C T
set
T
int
T
;
set
T
int
T
ext
STOP
DISPLAY;
MENU,
STOP.
–
30,00 T
set
T
ext
T
int
T
set
STOP
T
ext
DISPLAY,
MENU,
STOP
ECO Silver
The following information is displayed depending on the operating
status:
Pump runs with displayed pump level;
–
Heater is active;
–
Chiller is active;
–
Set-point temperature;
–
Current bath temperature;
–
Temperature of the external application (if external
–
temperature sensor is connected);
Soft-key bar; function call via associated keys;
–
The following information is displayed depending on the operating sta-
tus:
Pump runs with displayed pump level;
–
Heater is active;
–
Chiller is active;
–
Current bath temperature;
–
Set-point temperature;
–
Temperature of the external application (if external
–
temperature sensor is connected);
Soft-key bar; function call via associated keys;
–
47 / 124