Before Putting The Device Into Operation; Assembly And Siting - Lauda ECO GOLD Operation Manual

6

Before putting the device into operation

Please note:
The device can be operated up to an ambient temperature of 40 °C.
-
A higher ambient temperature can have a negative effect on the cooling output of the thermostats used.
-
When putting the chiller into operation after a lengthy shut-down, up to 30 minutes may pass until the rated refriger-
-
ating power is available depending on room temperature and device type.
6.1

Assembly and siting

Always comply with the following safety information:
Warning!
Affix the symbol "Hot surface".
The ECO thermostat is used as:
- Immersion thermostat (optionally with cooling coil and/or pump connection set),
- Heating thermostat (heating bath and circulation thermostat),
- Cooling thermostat (cooling/heating bath and circulation thermostat).
Assembly as immersion thermostat
26 / 137
Falling / toppling equipment on sloping surfaces / table edge
Crushing of hands and feet
Only site the device on flat surfaces, not near the edge of

the bench or table.
ECO Gold
Push the screw clamp on the underside of the control head
-
into the guide rails.
Insert the thermostat with the screw clamp into the tem-
-
perature control vessel ( 9) and screw the clamp tightly to
the bath edge with the knurled screw.
With plastic baths the tubular heating element must not
-
contact the bath wall.
Ensure that the ventilation opening at the back of the device
-
is free.
Keep a distance of at least 20 cm free on all sides of the de-
-
vice.
10/2019 i