Safety Considerations; Introduction - GE Invenia ABUS 2.0 Technical Publication

Introduction

Human Safety
DANGER
DANGER
WARNING
Invenia ABUS 2.0 – System Setup and Basic Service Manual
4700-0043-00 Rev. 4

Safety considerations

The following safety precautions must be observed during all
phases of operation, service and repair of this equipment.
Failure to comply with these precautions, or with specific
warnings elsewhere in this manual, violates safety standards of
design, manufacture and intended use of the equipment.
• Operating personnel must not remove the system covers.
• Servicing should be performed by authorized personnel
only.
Only personnel who have participated in an Invenia ABUS 2.0
Training Seminar are authorized to service the internal
components of this equipment.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING DEATH,
ARE PRESENT IN THIS EQUIPMENT. USE EXTREME
CAUTION WHEN HANDLING, TESTING AND ADJUSTING.
WHERE APPLICABLE, THERE ARE SEVERAL PLACES ON
THE IMAGING ENGINE CHASSIS, THE AC DISTRIBUTION,
DC DISTRIBUTION, AND TIP BOARD THAT ARE
DANGEROUS. BE SURE TO POWER DOWN THE SYSTEM,
TURN OFF THE MAINS POWER SWITCH AND
DISCONNECT THE MAINS POWER CABLE FROM THE
WALL OUTLET BEFORE YOU REMOVE ANY PARTS. BE
CAUTIOUS WHENEVER POWER IS STILL ON AND
COVERS ARE REMOVED.
If the covers are removed from an operating Invenia ABUS 2.0,
some metal surfaces may be warm enough to pose a potential
heat hazard if touched, even while in shutdown mode.
Safety considerations
1-13