GE Invenia ABUS 2.0 Technical Publication page 273

Numerics
3D volume, 4-12
functional check, 4-13, 8-11
A
abbreviations, 9-2
renewal parts, 9-2
acclimate time, 2-2
adjustment, 6-1
articulating arm, 4-14
average setup time, 3-2
B
B-Mode, 4-12
functional check, 4-13, 8-11
boot up, 4-4
connect power to the product, 4-5
C
care & maintenance, 10-1
caster wheels
and brakes, 4-14
change history, i-1
check connections, 3-70
cold or hot
if the unit is very cold or hot, 2-2
compliance, 1-22
connect
USB flash card, 3-43
connect power to the product, 4-5
connections
on the rear panel, 3-42
scan station to workstation, 3-70
connectivity functions checks, 4-15
console requirements, 2-2
environmental, 2-2
contact information, 1-24
contents in this manual, 1-2
conventions used in book, 1-8
cooling, 2-2
copyrights, i-18
covers and service table replacement, 8-15
customer assistance, 1-24
phone numbers, 1-25
Invenia ABUS 2.0 – System Setup and Basic Service Manual
4700-0043-00 Rev. 4
customer order
verification, 3-34
D
damage
in transportation, 3-6
damage in transport, i-15
dangerous procedure warnings, 1-16
data network setup requirements, 2-16
date format, 3-63
date setup
scan station, 3-49
diagnostics/troubleshooting, 7-1
DICOM network function, 2-16
DICOM setup requirements, 2-17
disposal
used media and used parts, 8-5
E
electrical
configurations, 2-9
electrical requirements, 2-3
EMI limitations
EMI limitations, 2-5
general requirements, 2-3
power stability requirements
power stability requirements, 2-4
power transients
power transients, 2-4
site power outlets
site power outlets, 2-3
unit power plug
unit power plug, 2-3
voltage drop-out
voltage drop-out, 2-4
electrical safety, 1-17
electrical specification, 3-41
electromagnetic compatibility (EMC), 1-22
electromagnetic interference
abatement, 2-6, 7-33
prevention, 2-6, 7-33
recommendations, 7-32
electrostatic discharge prevention, 1-23
EMC
compliance, 1-22
electromagnetic compatibility, 1-22
Index
Index-1