Intended Use; Range Of Application; Permissible Components - Festo CMMT-ST-C8-1C Series Manual

Safety
– Do not carry out repairs on the product. If defective, replace the product immediately.
– Observe labelling on the product.
– This product can generate high frequency malfunctions, which may make it necessary to implement
interference suppression measures in residential areas.
– Take into consideration the ambient conditions at the location of use.
The safety function might fail and malfunctions might occur if you do not comply with the parame-
ters required for the ambient and connection conditions.
– Never remove or insert a plug when the power is switched on.
– Install the product in a suitable control cabinet. The minimum degree of protection required for the
control cabinet is IP54.
– Prior to commissioning, ensure that the resulting movements of the connected actuator technology
cannot endanger anyone.
– During commissioning: systematically check all control functions and the communication and signal
interface between controller and servo drive.
– Keep the documentation in a safe place throughout the entire product lifecycle.
If damage is caused by unauthorised manipulation or any use other than the intended use, the
guarantee will be invalidated and the manufacturer will not be liable for damages.
If damage is caused by using unauthorised software or firmware with the device, the warranty is
invalidated, and the manufacturer is not liable for damages.
Safety instructions for the safety sub-functions of the product è Manual Safety sub-function.
2.2

Intended use

The servo drive CMMT-ST is intended to supply power to and to regulate a stepper motor or an EC
motor. The integrated electronics permit regulation of torque (current), rotational speed and position.
Use exclusively:
– in perfect technical condition
– in its original condition, without unauthorised modifications
– within the limits of the product defined by the technical data è Technical data
– in an industrial environment
Intended use of the safety sub-functions for the product è Manual Safety sub-function.
2.2.1

Range of application

The device is intended for use in an industrial environment.
The device is intended to be installed in a control cabinet. The minimum degree of protection required
for the control cabinet is IP54.
2.2.2

Permissible components

Supported motors:
– Stepper motors
– EC motors
8 Festo — CMMT-ST-C8-1C-...-S0 — 2021-04b