Bosch Rexroth IndraDrive X Operating Instructions Manual page 86

Table of Contents

70/123

Mounting, dismounting and electrical installation

Installation

Bosch Rexroth AG R911392532_Edition 01

IndraDrive X Drive Controllers Power Sections XCS1, XMD1,

Equipment grounding conductor: Material and cross section

For the equipment grounding conductor, use the same metal (e.g.

copper) as for the outer conductors.

For the connections from the equipment grounding conductor

connection of the device to the equipment grounding conductor

system in the control cabinet, make sure the cross sections of the

lines are sufficient.

Cross sections of the equipment grounding connections:

For Xxxn-W0nnn drive controllers, at least 10 mm

smaller than the cross sections of the outer conductors of the

mains supply feeder.

Additionally, mount the housing to a bare metal mounting plate.

Connect the mounting plate, too, with at least the same cross

section to the equipment grounding conductor system in the

control cabinet.

Connect ring cable lugs M5/T20 of equipment grounding conductors to

device housing (

symbol).

Tightening torque: 5 Nm

Mains

Motor

Fig. 10-15:

Connection point of equipment grounding conductor (XCS1-W01xx)

XMQ1

, but not

Table of Contents