GILBARCO VEEDER-ROOT FlexPay Encrypting PIN Pad Start-Up Ans Service Manual page 62

Start-up and Service
6 Remove the FlexPay EPP.
7 Mount the new FlexPay EPP on the unit using the screws removed in step
Reconnect the cables removed in step
8
Restore power to the unit.
9
Enter the Diagnostic Mode using the Diagnostic Card. Refer to
10
Using the CRIND Diagnostic Card"
Purge the memory.
11
12 When the unit comes up, enter the Diagnostic Mode again, program the CRIND IDs, CRIND
Mode, and enable any peripheral devices (Cash Acceptors, TRIND and so on).
13 In the Diagnostic Mode, run a Keypad Test to check all keys. For instructions, refer to
"Performing the Keypad Test"
Exit the Diagnostic Mode. For instructions, refer to
14
Run a debit transaction to verify proper operation.
15
Close the main dispenser door.
16
Page 58
4 on page
on page
on page 16.
MDE-4784D FlexPay™ Encrypting PIN Pad Start-up and Service Manual · December 2011
Replacing the FlexPay EPP
57.
"Entering Diagnostic Mode
15.
"Exiting Diagnostic Mode"
5 on page 57.
on page 18.