Volkswagen Golf 2015 Repair Manual page 61

– Disengage the selector lever cable -1- from the bracket -2- clip
-3-.
Note
Do not remove the clip -5-.
♦
Do not bend or kink the selector lever cable.
♦
– Remove the cable bracket -4- from the transmission to do this
remove the bolts -arrows-.
– If equipped, disconnect the Ground (GND) cable from the bolt
-3- on the transmission bracket.
– Remove the wires -1 and 2- from the starter.
– Removing starter. Refer to ⇒ Electrical Equipment; Rep. Gr.
27 ; Starter; Starter, Removing and Installing .
– Place lint-free cloth on to ATF cooler and transmission to ab‐
sorb exiting coolant.
Note
Mark the ATF cooler coolant hoses to prevent confusing them
♦
when installing them later.
The coolant system is under pressure when the engine is
♦
warm.
Cover the cap on the reservoir with a cloth and open it carefully
♦
before removing the coolant hoses.
– Clamp the coolant hoses with Hose Clamps - Up To 25mm -
3094- and remove them from the ATF cooler.
– Seal the coolant hoses and connections with plugs taken from
Engine Bung Set - VAS6122- .
– Remove the Secondary Air Injection Solenoid Valve - N112- .
Refer to ⇒ Engine Mechanical, Fuel Injection and Ignition;
Rep. Gr. 26 ; Secondary Air Injection System; Secondary Air
Injection Solenoid Valve - N112- , Removing and Installing .
Golf 2015 ➤ , Golf Variant 2015 ➤
Automatic Transmission - Edition 11.2014
3. Transmission, Removing and Installing
57