Volkswagen Golf 2015 Repair Manual page 104

Golf 2015 ➤ , Golf Variant 2015 ➤
Automatic Transmission - Edition 11.2014
– Remove the ATF pan. Refer to
⇒ 1.1 Oil Pan, Removing and Installing , page 84
– Remove the ATF strainer. Refer to
⇒ 1.2 ATF Strainer, Removing and Installing , page 86
– Remove the valve body. Refer to
⇒ 2.2 Valve Body, Removing and Installing , page 90
– Disconnect the solenoid valve connector -2- from the trans‐
mission connector.
– Remove the bolt from the 14-pin transmission connector.
– Remove the transmission connector with the wiring harness
outward from the transmission housing.
Install in reverse order of removal. Note the following:
– Replace the O-ring on the transmission connector.
– Coat the O-ring with ATF.
– Push the transmission connector with a new O-ring all the way
into the transmission.
– Tighten the bolt for the 14-pin transmission connector. For the
correct tightening specification. Refer to
– Install the valve body. Refer to
– Install the ATF strainer. Refer to
⇒ 1.2 ATF Strainer, Removing and Installing , page 86
– Install the ATF pan. Refer to
⇒ 1.1 Oil Pan, Removing and Installing , page 84
– Fill the ATF and check the level. Refer to
⇒ 7 Automatic Transmission Fluid , page 73
2.4.2 Wiring Harness, Removing and Instal‐
ling, Sensors
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ O-ring - 8-Pin Transmission Connector
– Drain the ATF. Refer to
⇒ 7.2 ATF, Draining and Filling , page 76
– Remove the ATF pan. Refer to
⇒ 1.1 Oil Pan, Removing and Installing , page 84
– Remove the ATF strainer. Refer to
⇒ 1.2 ATF Strainer, Removing and Installing , page 86
– Remove the valve body. Refer to
⇒ 2.2 Valve Body, Removing and Installing , page 90
100
Rep. Gr.38 - Gears, Hydraulic Controls
.
.
⇒ page 89 .
⇒ page 95 .
.
.
.
.
.
.
.
.