Volkswagen Golf 2015 Repair Manual page 51

– Remove the battery and the battery tray -1-. Refer to ⇒ Elec‐
trical Equipment; Rep. Gr. 27 ; Battery; Battery Tray, Remov‐
ing and Installing .
– Pry the selector lever cable -1- off the selector lever -3-, for
example, using a wrench.
The adjusting screw -2- must not be loosened.
– Disconnect the connector from the Multifunction Transmission
Range Switch - F125- .
– Disengage the selector lever cable -1- from the bracket -2- clip
-3-.
– Remove the cable bracket -4- from the transmission to do this
remove the bolts -arrows-.
Note
Do not remove the clip -5-.
♦
Do not bend or kink the selector lever cable.
♦
– Removing starter. Refer to ⇒ Electrical Equipment; Rep. Gr.
27 ; Starter; Starter, Removing and Installing .
– Place lint-free cloth on to ATF cooler and transmission to ab‐
sorb exiting coolant.
Note
Mark the ATF cooler coolant hoses to prevent confusing them
♦
when installing them later.
The coolant system is under pressure when the engine is
♦
warm.
Cover the cap on the reservoir with a cloth and open it carefully
♦
before removing the coolant hoses.
Golf 2015 ➤ , Golf Variant 2015 ➤
Automatic Transmission - Edition 11.2014
3. Transmission, Removing and Installing
47