Selector Shaft Seal, Replacing - Volkswagen Golf 2015 Repair Manual

Adjusting
– Place the Gauge - Multi Function Switch - T10173- on the se‐
lector shaft -2- and turn the Multifunction Switch -1- until the
Gauge - Multi Function Switch - T10173- locks into the tab on
the Multifunction Switch connector.
Note
If the tab on the connector does not engage in the Adjustment
Gauge groove, then the transmission is no longer in N . In this
case, shift the transmission into N using the Adjustment Gauge .
– Secure the Adjustment Gauge to the selector shaft -2- with the
bolt -3-.
– Tighten the bolts -arrows- to the tightening specification.
– Remove the Adjustment Gauge .
– Further installation is performed in the reverse sequence. Re‐
fer to ⇒ page 39 .
Tightening Specifications
Component
Multifunction Transmission Range Switch -
F125- on the transmission
2.11

Selector Shaft Seal, Replacing

Special tools and workshop equipment required
♦ Seal Installer - Selector Shaft Oil Seal - T10174-
♦ Puller - Crankshaft/Power Steering Seal - T20143/1-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Seal - Selector Shaft
Removing
– Remove the Multifunction Transmission Range Switch -
F125- . Refer to
⇒ 2.9 Multifunction Switch, Removing and Installing ,
page 37 .
– Carefully remove the selector shaft seal with the Puller -
Crankshaft/Power Steering Seal - T20143/1- . Be careful not
to damage the selector shaft when doing this.
Installing
– Coat the outer circumference and the sealing lip on the oil seal
with ATF.
• Installed position: Open side of the seal faces the transmission
housing.
Golf 2015 ➤ , Golf Variant 2015 ➤
Automatic Transmission - Edition 11.2014
Nm
6
41
2. Selector Mechanism