Cell Interface Electrical Connections; Getting Started - Nuvation Energy NUV300-BC-12 Product Manual

4.4. Cell Interface Electrical Connections

The Low-Voltage BMS system should not be used with a battery stack that exceeds

60 V DC during normal operation.
Please see

4.4.1. Getting Started

To complete the installation of the Cell Interface, the following is required per Cell Interface module:
1. 1x Battery Cells cable
2. 1x Thermistor cable
3. 1x Link Bus (LV to CI) cable
These cables are available for purchase as a kit.
Figure 30. Example Low-Voltage Cell Interface kit (NUV100-CI-12-KIT-LV-2)
The instructions below are for applications using cable harnesses purchased from Nuvation Energy. To
build custom cables, refer to
Connection sequence
▪
Step 1: Connect Temperature cable
▪
Step 2: Connect Battery Cells cable
▪
Step 3: Connect Link Bus cable
Document ID: NE-PM-002
Section 4.4.3.1.1 for safety considerations.
Section 9.2 for connector pin-out and specifications.
for temperature measurement of the cells
to battery voltage sense leads
to BMS module(s)
Nuvation Energy Low-Voltage BMS - Product Manual
39 Rev 1.2, 2021-03-03
Curie Update 1