First-Time Power-Up - Nuvation Energy NUV300-BC-12 Product Manual

Nuvation Energy Low-Voltage BMS - Product Manual

4.4.5. First-time Power-up

Once the Low-Voltage BMS is connected to the battery (including the Cell Interface modules chain),
the Low-Voltage BMS can be powered. The Low-Voltage BMS activity LED (green) should turn ON.
On initial power-up, it is common to see that the fault LED (red) is also ON. This indicates that a fault
has been detected; the next step will be to clear this fault.
The Low-Voltage BMS can now be connected to a network, either through a network switch or directly
to a computer/laptop's network adapter. The default IP address of the Low-Voltage BMS is
192.168.1.21. Refer to the subsequent Section 5 and Section 6 for instructions on setup and using
the Operator Interface.
Document ID: NE-PM-002 47 Rev 1.2, 2021-03-03
Curie Update 1