Run Inertion Cycle - 3D Systems DMP Flex 350 User Manual

5.3.2 Run Inertion Cycle
1. On the PC, open DMP Control (1) and open the applicable
job or scan the bar code to allow DMP Deposition (2) to
check if enough powder is present to complete the job.
2. Open DMP Deposition.
3. Select the Manual tab and click the Prep Cycle button.
4. The Automatic inertion cycle window will pop-up. Press
Start and confirm the choice of material to initiate the
inertion cycle.
Caution: The inertion cycle cannot be initiated as
long as the maintenance schedule shows
maintenance tasks that still need to be
completed.
3D Systems, Inc. 66
1
2
p/n: 15-D100, rev. D