Restart After Emergency Off; Shut Down Dmp Flex - 3D Systems DMP Flex 350 User Manual

5.8.3 Restart after Emergency Off
1. Resolve the cause of the emergency stop.
2. Release the emergency off button that has been pressed.
3. Press the ON button to restart the system.
4. Wait +/- 1 min for the oxygen sensors to warm up.
5. Open DMP Deposition.
Caution: Whenever an emergency off button has been pressed, alarm messages may pop up when opening
DMP Deposition after recovery. Wait 2 minutes for sensors to stabilize before clearing the alarm messages.
Caution: Depending on the quality requirements of the finished product, the print job may or may not be
restarted after an emergency stop interruption. Continuing the print job after an emergency stop will leave a
visible line on the printed part. This line can be removed during the finishing.
5.9 Shut down DMP Flex 350
To completely shut down the DMP Flex 350 system, follow the
next steps:
1. Close all open applications.
2. In Windows, click Start > Shut down to turn off the PC. Wait
for the PC to turn off.
3. Turn off the 24VDC power switch on the control panel at
the rear of the printer.
4. Turn off the main power switch on the electrical cabinet of
the printer.
3D Systems, Inc. 80 p/n: 15-D100, rev. D