Tabs - 3D Systems DMP Flex 350 User Manual

4.5.4 Tabs

Click the icons shown above to access the following menus:
• Manual: manually control the machine and perform actions
• Run Job: window that will be shown during printing
• Maintenance: opens up the Maintenance tasks module
• Message: opens up the User Message screen
• Light: will turn on/off the light inside the process chamber
• Actuators: will open up the Actuators window
• Sensors: will open up the Sensors window
• Protect: will open up the Protect window
A. Manual Operation
Click the tab Manual to open the Manual operation.
In the task bar, click the Manual button to open the Manual operation window.
Coater Movements
1 2
1. Move coater to left end position
2. Move coater left until button is released
3. Move coater to middle left (only available when coater is left of the build platform)
4. Move coater to middle right (only available when coater is right of the build platform)
5. Move coater right until button is released
6. Move coater to right end position
3D Systems, Inc.
3
49
4 5 6
p/n: 15-D100, rev. D