Table of Contents
Advertisement
April 2021
Note
The alert "Probe life" is available only for ER probes.
Table 3-5: Advisory alerts
Advisory alerts
Measurement disabled
Instrument board
always ON
User alerts 1 to 8
Configuration items
updated
Device variable
simulation active
Power supply
conditions out of range
Environmental conditions
out of range
Device configuration
locked
Event notification
overflow
Capacity denied
Bandwidth allocation
pending
Table 3-6: Failure alerts
Alert message
Probe malfunction
Quick Start Guide
Device status
Description
(Byte :: Bit)
0 :: 6
Measurements are disabled.
0 :: 7
The instrument board is set to
ignore power saving. The setting is
only intended for software updates.
1 :: 0 to 7
User configurable alerts
3 :: 0
The configuration items were
updated as a result of a software
update, probe type change, or a
reset to factory defaults
8 :: 0
One or more of the device variables
are being forced to a simulated
value and status.
8 :: 4
The supply voltage is out of the
specified range.
8 :: 5
Device temperature is above or
below the operational limit.
8 :: 7
The device is in write protect mode.
9 :: 2
Event queue overflow resulting in
event not being recorded
12 :: 0
The device was unable to acquire
the communication bandwidth
required to support the Burst
Messaging specified.
12 :: 2
The device has asked for bandwidth
from the Network Manager, and is
awaiting Network Manager
response.
Device status
Description
(Byte :: Bit)
0 :: 0
Due to an internal error, a
measurement was not performed
correctly.
Quick Start Guide
17
Advertisement
Table of Contents
