Optional) Setting Monitor Parameters - Huawei NetCol8000-A013 User Manual

NetCol8000-A013 In-room Air Cooled Smart Cooling
Product
User Manual (600 mm Width)
Setting
Item
Low Temp
Start All
Temp for
LT Start
All
Step 6 After the setting is complete, tap
----End

4.5 (Optional) Setting Monitor Parameters

Procedure
Step 1 Choose Comm Setting from the user menu, and tap
communication setting screen.
Figure 4-10 Communication settings
Step 2 Set Baud Rate, Comm Address, and Enable Monitoring Resistor based on site
requirements.
Issue 02 (2020-11-09)
Description
When it is enabled,
if the return air
temperature is
higher than Low
Temp Start All, all
the smart cooling
products in a group
will start heating
simultaneously.
-
Copyright © Huawei Technologies Co., Ltd.
4 Power-On Commissioning
Setting Principle
You are advised not
to change the value.
You are advised not
to change the value.
to return to the user menu.
Default Value
Disable
13°C
to access the
72