Huawei NetCol8000-A013 User Manual page 114

NetCol8000-A013 In-room Air Cooled Smart Cooling
Product
User Manual (600 mm Width)
Procedure
Step 1 Hold down
screen displayed.
Step 2 Open the front door, and turn off the indoor unit circuit breaker and circuit
breaker in the power distribution cabinet.
Step 3 Use a Phillips screwdriver to remove the six screws that secure the fan cover, and
remove the fan cover, as shown by (1) in
Figure 5-3 Removing a wet film humidifier
Step 4 Use a Phillips screwdriver to remove the hoop of the water inlet pipe and remove
the pipe, as shown by (2) in
Step 5 Use a Phillips screwdriver to remove the screw that secures the wet film humidifier
and pull out the humidifier, as shown by (3) and (4) in
Step 6 Install the new wet film humidifier in the sequence from
Step 7 Power on the equipment, choose Maintain > Performance Maintain on the home
screen, and clear the total runtime of the wet film humidifier.
Step 8 Tap
displayed. Ensure that the smart cooling product is running normally without any
alarms.
----End
Issue 02 (2020-11-09)
on the home screen. Tap Yes on the shutdown confirmation
Figure
on the home screen, and tap Yes on the start confirmation screen
Copyright © Huawei Technologies Co., Ltd.
5 System Operation and Maintenance
Figure 5-3.
5-3.
Figure 5-3.
Step 5 to Step 3.
107