Angelo Po 091CP1G Use And Installation Manual page 22

Important
This adjustment is only required if the type
of gas to be connected is different from that
used for testing after the conversion proce-
dure has been carried out (see page 18).
Before making this adjustment, check that
the gas supply pressure is the same as the
rated pressure for the type of gas in use
(see table at back of manual).
Natural gas
Proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and remove the control
panel (C).
4 - Undo the screw (D) of the pressure con-
nection.
5 - Connect the pressure gauge (E) to the
pressure test point (F).
6 - Turn the gas supply tap back on.
7 - Light the burner and turn the knob to the mini-
mum flame setting.
8 - Remove the minimum flame injector (G) and re-
place it with the one suitable for the type of gas
in use (see table at back of manual), screwing
IT
it fully down.
9 - Slowly unscrew the injector (G) until the pres-
sure reading complies with the values in the ta-
AUS
ble (see back of manual).
10 - Check the stability of the flame.
DE
11 - After making the setting, seal the screw with
paint.
FR
12 - Switch off the burner, turn off the gas supply tap
and disconnect the pressure gauge.
13 - Replace the control panel (C) and the knobs (A)
ES
on completion of the operation.
English
ADJUSTING GAS CONTROL VALVE MINIMUM SETTING
B
A
B
C
Liquid gas
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and remove the control
panel (C).
4 - Remove the minimum flame injector (G) and re-
place it with the one suitable for the type of gas
in use (see table at back of manual), screwing
it fully down.
5 - After making the setting, seal the screw with
paint.
6 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
- 20 -
G
F
D
E
IDM-39614901600.tif