Angelo Po 091CP1G Use And Installation Manual page 20

2 - Open the hatch (B).
3 - Undo the screws (C) to remove the guard (D).
4 - Connect the circuit-breaker (A) to the terminal
board (E) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual. Use a cable with at
least H05RN-F characteristics.
Always install a quick-closing ON/OFF valve (A) (not
supplied). For Natural gas equipment, fit the gas regu-
lator (B) supplied with appliance to gas connection.
IT
Caution - warning
AUS
This appliance must be fitted with a Bromic Oara
980L gas regulator for Natural Gas or a Bromic
986L gas regulator for U-LPG (AGA Approval
DE
No.5862) supplied with the appliance. Do not use
any other gas regulator.
FR
Ensure regulator is fitted with respect to the gas
flow marked on the housing of the regulator.
ES
The constructor has tested the appliance with its
own mains gas, identified by the sticker applied to
the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
1 - Turn off the gas supply tap (A).
2 - Change the burner nozzle (see page 22).
3 - Change the pilot light nozzle (see page 22).
4 - Adjust the minimum settings of the gas control
valves of the burners (see page 20).
5 - If necessary, adjust the burner primary air
(see page 21).
English
B
A
CONVERSION OF GAS SUPPLY
Important
When connecting, take care over the con-
nection of the neutral and earth wires; if
they are not connected correctly, the burn-
er does not light.
5 - Replace the guard (D).
6 - Close the door (B) when the operation is com-
plete.
C
D
C
A
- 18 -
E
IDM-39614901500.tif
B
IDM-39614601700.tif
A