Angelo Po 091CP1G Use And Installation Manual page 11

FILLING AND EMPTYING THE WELL
Filling
The well can be filled in a number of different ways.
Quick no-limits filling.
– Press and turn the knob (C) to 1 to fill the well to
the level required. When the water reaches the
maximum level, the burner can be lit and the dif-
ferent top-up modes can be enabled.
Important
After filling, the knob (C) must be turned to
another position as otherwise water may
overflow from the well.
Quick automatic top-up.
– Turn the knob (C) to 2 to fill the well to the maxi-
mum level automatically when the water level
drops below the minimum threshold.
Slow automatic top-up.
– Turn the knob (C) to 3 for a slow, continuous flow
of water that keeps the water level inside the well
constant.
Important
If the water drops below the minimum level,
the "quick automatic top-up" mode is auto-
matically triggered.
Emptying
1 - Turn the knob (C) to 4 to shut off the water sup-
ply.
2 - Turn on the tap (D) to empty the well.
Important
The water drained from the appliance must pass
through a suitable drain line, resistant to a tem-
perature of at least 100° C.
The steam produced when the well is drained
must not come into contact with the appliance
(see also connection diagram at back of manual).
LENGTHY DOWNTIMES OF APPLIANCE
If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Turn off the gas supply tap.
2 - Clean the appliance and the surrounding areas
thoroughly.
3 - Spread a film of edible oil over the stainless
steel surfaces.
C
4
D
4 - Carry out all the servicing procedures.
5 - Leave the appliance uncovered and the cook-
ing chambers open.
Important
Drain the well completely after use and cle-
an it.
- 9 -
1
2
3
IDM-39614900900.tif
IDM-39614901000.tif
C
IT
AUS
DE
FR
ES
English