Table of Contents
Advertisement
Chapter 4
Figure 4-14: Typical Sensor Expander
Alternatively, click on
shown in Figure 4-15.
Figure 4-15: Typical Sensor Temperature Dialog
6. Open the Spectrometer expander and program the desired Center Wavelength.
For example, in Figure 4-16, the 1200 g/mm, Blaze: 550 nm Grating has been
factory installed, and the Center Wavelength is programmed to 546 nm for a
mercury (Hg) lamp.
Figure 4-16: Typical Spectrometer Expander
7.
Verify that an appropriate incoming light source is installed and turned on.
8. Click
Getting Started
to open the Sensor Temperature dialog,
to begin data acquisition.
31
Advertisement
Table of Contents
