Grating Carrier Alignment; Grating Carrier Adjustment Screws - Teledyne Princeton Instruments IsoPlane 81 Manual

46
14. Now that a new Grating Carrier has been installed, it must be aligned. Proceed to
Section C.2.
C.2

Grating Carrier Alignment

This section provides information necessary to align an IsoPlane 81 Grating Carrier.
The following tools are required to align an IsoPlane 81 Grating Carrier:
•
•
•
•
C.2.1

Grating Carrier Adjustment Screws

Figure C-11 shows the locations of all adjustment screws required to align an IsoPlane
81 Grating Carrier.
Figure C-11: Grating Carrier Adjustment Screws
Refer to Table C-1 for information about each adjustment screw, listed alphabetically by
label/identifier.
Table C-1: Grating Adjustment Screw
Label/Identifier
®
IsoPlane 81 Imaging Spectrometer System Manual
0.05" Allen wrench
5/64" Allen wrench
3/32" Allen wrench
1/8" nut driver
Adjustment/Purpose
A1 Tilt adjustment.
A2 Tangent adjustment.
L11 Tilt adjustment, initial lock.
L12 Tangent adjustment, initial lock.
L21 Tilt adjustment, final lock.
L22 Tangent adjustment, final lock.
s
Adjustment Tool
0.05" Allen wrench
5/64" Allen wrench
3/32" Allen wrench
1/8" nut driver
3/32" Allen wrench
1/8" nut driver
Issue 1