Table of Contents
Advertisement
Chapter 4
4.4
Attach Focusing CUBE
Once the slit has been focused, perform the following procedure to install the Focusing
CUBE:
1.
Install the Focusing CUBE by aligning the stainless steel pins and carefully pressing
the CUBE onto the instrument. See Figure 4-6.
Figure 4-6: Installing the Focusing CUBE
2. Using the #1 Phillips head screwdriver, turn the coupling screw clockwise until
finger tight. See Figure 4-7.
Getting Started
NOTE:
Tightening the bottom screw is necessary only if installing
additional CUBES to the Focusing CUBE.
25
Advertisement
Table of Contents
