NEC Express5800 Series User Manual page 96

Chapter 3 Setup
(2)
Memory Configuration submenu
From the Advanced menu, select Memory Configuration and then press the <Enter> key to display the menu
screen shown below. For the menu that has
key to show its submenus.
For details about the options, see the table below.
Option
Memory Information
Hardware Memory Test
Memory Retest
Memory Frequency Limit
Memory Voltage
Memory Voltage
NUMA
96
on the left, move the cursor to it and then press the <Enter>
Parameter
–
[Disabled] Enable or disable to execute memory test during POST.
If a memory error is detected while this option is set to
Enabled
Enabled, the relevant memory resource is degraded.
[No] When this option is set to Yes, all DIMMs are
reconfigured at POST. No is automatically selected after
Yes
DIMMs are reconfigured.
[Auto] Specify the upper limit of operating frequency of
memory. The operating frequency may be lowered than
800 MHz
the specified value depending on memory configuration.
1066 MHz
1333 MHz
1600 MHz
1.5 V Specify the operating voltage of memory. The memory
voltage may differ from that specified in this parameter
[1.35 V]
depending on memory configuration, because the
setting may be changed for safe operation of DIMM.
Normal Specify the operating voltage of memory. Selecting
Normal increases power consumption, but clock
[Low]
frequency becomes faster.
Disabled Enable or disable Non-Uniform Memory Access feature.
This option is displayed only in 2-CPU configuration.
[Enabled]
Express5800/B120d, B110d User's Guide
2. Details of System BIOS
Descriptions
–