NEC Express5800 Series User Manual page 116

Chapter 3 Setup
Option
Thermal Sensor
Check previous System
Config
BMC IRQ
Post Error Pause
Memory Error
Power Switch Inhibit
CLI SETUP
116
Parameter
Disabled Enable or disable the thermal sensor monitoring function. If this
option is set to Enabled and when abnormal temperature is
[Enabled]
detected, the system stops at the end of POST, and waits until
the temperature becomes normal.
[Disabled] Enable or disable the feature to detect system configuration
change.
Enabled
If this option is set to Enabled and the system configuration
differs from the previous boot, the system stops before OS
booting and displays confirmation message whether to continue
booting. At this time, POST pauses until user's response is made.
[IRQ 11]
Specify whether to allocate interrupt lines for BMC (Baseboard
Disabled
Management Controller).
Disabled Enable or disable the feature to suppress OS booting when
POST detects an error, until user's response is made.
[Enabled]
When set to Disabled, continues OS booting regardless of user's
response even if an error is detected during POST.
Halt Specify whether to stop operation at the end of POST processing
if a memory resource error occurred while executing POST. This
[Boot]
setting is enabled if POST Error Pause in the Server menu is
enabled.
Even if this option is set to Boot, operation stops at the end of
POST if errors occurred for all resources.
[Disabled] Enable or disable the power switch inhibit feature.
Enabled
[Disabled]
When this option is set to Enabled, the BIOS Setup utility is run
Enabled
by the CLI SETUP (Command Line Interface SETUP Menu)
instead of the MENU SETUP. To switch back to the MENU
SETUP, set this option to Disabled in the CLI SETUP menu.
Express5800/B120d, B110d User's Guide
2. Details of System BIOS
Descriptions
[ ]: Factory settings