NEC Express5800 Series User Manual page 64

Chapter 2 Preparations
(1)
Procedure 1
1. Shutdown the CPU blade system and turn off the power of the CPU blade.
2. Replace the Hard Disk Drive.
3. Set up the system again.
Important
(2)
Procedure 2
1. Delete all the volumes and partitions on the Hard Disk Drive to be removed.
To delete volumes and partitions, select Programs
Management from the Start menu.
Select Delete volume / Delete partition from the menu appearing by right-clicking on Volume/Partition.
Important
2. Shutdown the CPU blade system and turn off the power of the CPU blade.
3. Remove the Hard Disk Drive.
4. Install the Hard Disk Drive.
5. Turn on the power of the CPU blade.
6. Delete the removed disk.
To delete the disk, select Program
from the Start menu.
Right-click the removed disk in the Disk Management menu to select Delete disk.
7. Import the installed Hard Disk Drive.
To import the disk, select Program
from the Start menu.
The installed drive has a different format. Right-click on the installed drive and select Import disk of different
format.
8. If NEC ESMPRO Agent is used, reset the Hard Disk Drive (refer to Chapter 2 (1.8.4 Resetting Management
Information).
64
Because the data cannot be recovered in this procedure, take the proper action
such as data backup if necessary.
Administrative Tool
Delete volumes and partitions carefully. Pay attention not to delete volumes
and partitions from a normal disk.
The volume and partition deletion disables the data to be recovered. Take the
proper action such as data backup if necessary.
Administrative Tool
Administrative Tool
Express5800/B120d, B110d User's Guide
1. Installing Internal Optional Devices
Computer Management
Computer Management
Computer Management
Disk
Disk Management
Disk Management