NEC Express5800 Series User Manual page 100

Chapter 3 Setup
(a) PCI Device Controller and Option ROM Settings submenu
For details about the options, see the table below.
Option
LAN1 Option ROM Scan
LAN2 Option ROM Scan
Mezzanine
Slot 1 Option ROM Scan
Slot 2 Port 1 Option ROM
Scan
Slot 2 Port 2 Option ROM
Scan
PCI Slot Option ROM Scan
― I/O Blade
See the next page for this item.
This item is displayed when N8404-001 Additional HDD Blade is installed.
Note
100
Parameter
Disabled
Enable or disable the option ROM SCAN for on-board
[Enabled]
LAN 1.
[Disabled]
Enable or disable the option ROM SCAN for on-board
Enabled
LAN 2.
[Disabled]
Enable or disable the option ROM Scan on each
Enabled
Mezzanine slot.
With B110d, Slot 2 Option ROM is not displayed.
Disabled
This item is displayed only when N85403-059 is
[Enabled]
installed.
Enable or disable the option ROM SCAN on BIOS of
N85403-059.
For a RAID Controller, LAN card (network boot), or Fibre Channel controller, if no Hard
Disk Drive on which an OS is installed is connected, set the option ROM for that slot to
Disabled.
Express5800/B120d, B110d User's Guide
2. Details of System BIOS
Descriptions
[ ]: Factory settings