Rear Panel; Wiring The Power Connector - Extron electronics DVC RGB-HD A User Manual

Rear Panel

A A A
Figure 3.
A
B
C

Wiring the Power Connector

The DVC RGB-HD A requires a 12 VDC, 1 A power supply to power it.
CAUTION: The wires must be kept separate while the power supply is plugged in.
ATTENTION : Les deux cordons d'alimentation doivent être tenus à l'écart l'un
ATTENTION:
NOTE: The 12 VDC power supply is not included, but can be ordered at
B B B
POWER
12V
0.2A MAX
OUTPUT
DVC RGB-HD A Rear Panel
Power connector — Connect a 12 VDC power supply between this 2-pole, 3.5 mm
captive screw connector and a 100 to 240 VAC, 50 Hz or 60 Hz power source. See
Wiring the Power Connector
HDMI output connector — Connect an HDMI sink to this female HDMI connector.
No input signal — When there is no input signal present, this connector does not
•
output TMDS data or clock activity. This ensures that any downstream device does
not erroneously detect a signal.
Output 5 V mode — This mode is configurable via SIS commands (see the
•
5 V Output Hot Plug Mode
Always enabled — The 5 V pin is always active, regardless of the input signal
•
status. This enables the unit to detect hot-plug assertion and read the EDID
from a connected sink.
Auto — 5 V output is active only when a source is connected to the input. If
•
no source is connected the 5 V output is disabled. (This may be necessary for
some sinks to enter power save mode.)
Secure the HDMI output cable to the HDMI connector using the LockIt bracket (see
Securing the HDMI Connector Using the LockIt Cable Lacing Bracket
page 7).
Config port — Use a USB A-to-mini B cable to connect this port to a USB port on the
computer.
Remove power before wiring.
de l'autre quand l'alimentation est branchée. Couper l'alimentation avant de faire
l'installation électrique.
•
Do not connect any external power supplies until you have read the
notifications
beginning on the next page.
•
Ne branchez pas de sources d'alimentation externes avant d'avoir lu
garde
sur la page suivante.
www.extron.com.
CONFIG
C C C
for the connection procedure.
commands on page 16). Select either of the following:
DVC RGB-HD A • Installation
on
Attention
les mises en
5