Download A Configuration; Upload A Configuration - ETC sensor+ CEM+ Configuration Manual

Below is what the sensor.rak file looks like viewed in this manner.
D o w n l oa d a C o n f i g u r a t i o n
To download a configuration file to disk, just right-click on the file name and select "Save
Target As...". This will bring up a standard dialog box asking you to name the file and to pick
a location to save it. It will append the file name with ".xml" instead of the file extension listed
on the web page. This will not prevent you from uploading the configuration file to a CEM+
later.
U p l o a d a C o n f i g u r a t i o n
Browse to the File Upload web page and click
Browse to select a file to upload to the local
CEM+. Once the file is selected, click Install and
the file will begin to transfer to the CEM+. This is
the same place and manner to send either a
configuration file or a software file. The CEM+
looks at the file being sent to automatically handle the file type or part of the configuration
file. In the same way, it doesn't matter if the file ends with .rak or .xml when it is sent.
4
CEM+ Configuration Procedures 44