Honda GX270 Owner's Manual page 3

3RZ7E6000.fm 3 ページ ２０１２年１１月２０日 火曜日 午後２時３９分
FEATURES
OIL ALERT SYSTEM (applicable types)
The Oil Alert system is designed to prevent engine damage caused
by an insufficient amount of oil in the crankcase. Before the oil
level in the crankcase can fall below a safe limit, the Oil Alert
system will automatically stop the engine (the engine switch will
remain in the ON position).
If the engine stops and will not restart, check the engine oil level
(see page 9) before troubleshooting in other areas.
CIRCUIT PROTECTOR (applicable types)
The circuit protector protects the
battery charging circuit. A short
circuit, or a battery connected with
reverse polarity, will trip the circuit
protector.
The green indicator inside the circuit
protector will pop out to show that the
circuit protector has switched off. If
this occurs, determine the cause of
the problem, and correct it before
resetting the circuit protector.
Push the circuit protector button to
reset.
BEFORE OPERATION CHECKS
IS YOUR ENGINE READY TO GO?
For your safety, to ensure compliance with environmental
regulations, and to maximize the service life of your equipment, it is
very important to take a few moments before you operate the
engine to check its condition. Be sure to take care of any problem
you find, or have your servicing dealer correct it, before you
operate the engine.
Before beginning your pre-operation checks, be sure the engine is
level and the engine switch is in the OFF position.
Always check the following items before you start the engine:
CIRCUIT
Check the General Condition of the Engine
PROTECTOR
1. Look around and underneath the engine for signs of oil or
gasoline leaks.
2. Remove any excessive dirt or debris, especially around the
ON
muffler and recoil starter.
3. Look for signs of damage.
OFF
4. Check that all shields and covers are in place, and all nuts,
bolts, and screws are tightened.
Check the Engine
1. Check the fuel level (see page 8). Starting with a full tank will
help to eliminate or reduce operating interruptions for refueling.
2. Check the engine oil level (see page 9). Running the engine with
a low oil level can cause engine damage.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below safe limits. However,
to avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.
3. Check the reduction case oil level on applicable types (see page
9). Oil is essential to reduction case operation and long life.
4. Check the air filter element (see page 10). A dirty air filter
element will restrict air flow to the carburetor, reducing engine
performance.
5. Check the equipment powered by this engine.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
be followed before engine startup.
ENGLISH
Improperly maintaining this engine, or failure to
correct a problem before operation, can cause a
malfunction in which you can be seriously hurt or
killed.
Always perform a pre-operation inspection before
each operation, and correct any problem.
3