INSTALLATION AND STARTUP (CONTINUED)
Warnings
7) This unit should not be operated without all Guards and Covers in place.
8) Before starting, unit should be entirely free to follow movement produced
by the Drive System. Screen frame must be free from hindrance or burden of
secondary chutes and hoppers.
9) User is responsible for incorporating unit such that all relevant require-
ments of Machinery Directive are met.
10) User is responsible for incorporating suitable access; providing Stairs &
Walkways in accordance with the EN 14122 Series of Standards and all other
Machinery Directive regulations.
11) User is responsible for Electromagnetic Compatibility of unit.
12) User is responsible for incorporating unit such that it does not present an
Ergonomic Hazard to the operator.
13) User is responsible for installing unit such that there are no hazards due
to poor visibility.
14) User is responsible for incorporating unit such that the electrical circuit
complies with relevant Machinery Directive Essential Health & Safety Re-
quirements & EN 60204-1, including Main Isolating Disconnect, Over current &
Overload Protection, E-Stop & Controls etc.
15) After unit is secure and in place remove all shipping lugs.
16) The standard unit has a single 2-pole on/off switch located on the motor
housing cabinet.
17) Momentarily energize motor to check that rotation is in proper direction.
Rotation is counter-clockwise. Refer to Figure 3 for shaft direction.
SPONGE-JET 70P 70E USER MANUAL |
9
Need help?
Do you have a question about the 70P Recycler and is the answer not in the manual?