Monitor/Finder setting to Monitor (Manual) prior to installing the camera inside the housing.
This should be done through the settings menu of the camera.
8. It is also recommended to program the camera to the most frequently used settings prior to
installing the camera in the housing. Such optional settings include assigning functions to custom
buttons (C1, C2) and customizing menu items to include most frequently used items.
WHEN USING THE HOUSING FOR THE FIRST TIME
1. Peel the transparent plastic screen protector
off the back door exterior of the housing.
2. Install the hand lanyard on the housing by
inserting it through the lanyard loop on the
bottom right of the housing (facing from back),
then pulling it through itself and testing it in
order to make sure it is secure (image #2).
3. Open the housing (see section "Opening the
Housing") and remove the anti‐glare hood out
of the housing. Secure the anti‐glare hood to
the housing by tying its secure string around the lanyard loop at the bottom left side of the
housing. Install the anti‐glare hood over the anti‐glare hood rails at the back of the housing. First
install the anti‐glare hood over the top rail (image #3) and then gently and carefully stretch it
downwards to install it on the bottom rail, making sure it's sitting securely on both upper and
lower rails (image #4).
Image #3
4. Installing the Extended Shutter Trigger – When mounting the housing on a tray & handle or tray
& arm system, you might consider replacing the shutter release trigger with the extended
replacement trigger included in the package. The extended trigger provides easier access to the
shutter release when an arm or handle are mounted next to the housing. To replace the shutter
release trigger with the extended one included, complete the following steps:
Image #2
Image #4
17
FA6400 Housing Instruction Manual 20190416